Quick answer: To dig an egress window well in Davis County, get a building permit, then contact Blue Stakes of Utah at least 3 business days before excavating and hand dig within 2 feet of any marked lines. Size the well to at least 9 sq ft with a 36-inch projection and width, give it a gravel base that drains, and plan around the area’s 30-inch frost depth.

Key takeaways

What size does an egress window well need to be?

At least 9 sq ft of floor area, with a minimum 36-inch horizontal projection out from the wall and a minimum 36-inch width. If the well is deeper than 44 inches, it needs a permanent ladder or steps.

These figures come from the IRC, which Utah has adopted (2021 edition). Confirm them with your city’s building department, since local amendments and plan reviewers can add details.

Egress item IRC 2021 requirement
Net clear opening, below-grade window 5.0 sq ft minimum (5.7 sq ft for most other openings)
Net clear opening height 24 inches minimum
Net clear opening width 20 inches minimum
Sill height above the floor 44 inches maximum
Window well area 9 sq ft minimum
Well projection and width 36 inches minimum each
Ladder or steps Required when the well is deeper than 44 inches

The well also has to let the window open fully. A casement window, for example, needs room to swing without hitting the well liner. For the bedroom side of the rules, see our basement bedroom egress guide, and for how windows compare with doors, see egress window vs. door requirements in Utah.

How do you call Blue Stakes before digging a window well?

Submit a locate request with Blue Stakes of Utah at least 3 business days before you dig. The requirement applies to egress excavation just like any other digging.

  1. Mark your dig area. Know exactly where the well will go and roughly how large the excavation will be.
  2. Submit the request. Use the online system any time, or call 811 or (801) 208-2100. Homeowners choose the “DIY’er” path.
  3. Wait the required time. Allow at least 3 business days before digging.
  4. Check the markings. Utility locators mark lines with paint or flags.
  5. Hand dig near the lines. Within 2 feet on either side of a marking, dig by hand to expose the line safely before using machinery.

Gas meters, electrical service lines, cable and phone lines often run along the same side of the house where an egress window would make sense. Locates protect your crew and your utilities.

How should an egress window well drain?

Water that collects in a well ends up against your new window. Every well needs a way for rain and snowmelt to soak away or drain off, not pond against the glass.

Common drainage approaches

Keep surface water out

The right drainage method depends on your soil, existing drains and lot grading, so ask your contractor to explain theirs before digging. If you have had water in the basement before, review the signs of basement water damage and fix grading issues first.

How do frost depth and snow affect an egress window well in Davis County?

They shape how the well is backfilled, drained and covered. Clearfield’s 2026 design criteria list a 30-inch frost line depth, a 39 psf ground snow load and a 10°F winter design temperature.

Frost

Wet soil that freezes can expand and push on a well liner. Backfilling around the liner with free-draining material and keeping the base drained reduces that pressure. Frozen ground can also slow excavation, so many contractors schedule digging during milder stretches.

Snow and covers

A cover keeps snow, leaves and debris out of the well. Choose one rated for the snow and foot traffic it will see, and keep it clear. Any cover or grate over an egress well must be releasable from inside without keys, tools or special knowledge, so a person can still escape. Confirm cover requirements with your city’s building department.

Do you need a permit to dig an egress window well?

Yes, plan on it. Cutting an opening in a foundation wall changes the structure, and the window and well are part of the bedroom’s egress compliance.

Most Davis County basement finish permits include egress windows on the drawings. Layton, for example, asks for a Basement Finish/Remodel Plan Submittal Checklist and site plan through its Building Division. For parcels outside city limits, Davis County building permits list basement finishing as permit-required. Our city-by-city permit guide covers the rest.

Show the opening size, any header or lintel over the new opening, the window specification and the well dimensions. Your city may ask for engineering on the cut, depending on the wall and opening size.

What does a typical egress well dig look like in Davis County?

The sequence for an egress window well Davis County homeowners add is similar whether you live in Layton, Kaysville, Syracuse or Bountiful. Site conditions change the details.

  1. Permit approved, with the egress window and well on the drawings.
  2. Blue Stakes request submitted at least 3 business days ahead.
  3. Hand dig near marked lines, then excavate to the planned depth.
  4. Cut the foundation opening and install any required header.
  5. Set the window, flash and seal it.
  6. Install drainage, set and anchor the well liner, and add gravel.
  7. Backfill, grade away from the well and add a ladder or steps if required.
  8. Install the cover and pass inspection.

Soil and slope vary across the county. On sloped lots in Bountiful, Farmington or Fruit Heights, check where uphill runoff will flow toward the well. In lower-lying areas of west Davis County, ask your contractor how they will manage wet soil during excavation.

Frequently asked questions

How big does an egress window well have to be in Utah?

Under the IRC, which Utah has adopted (2021 edition), an egress window well must have at least 9 sq ft of floor area, with a minimum 36-inch horizontal projection and 36-inch width. Wells deeper than 44 inches need a permanent ladder or steps. The well must also let the window open fully. Confirm requirements with your city’s building department before building.

Do I need to call Blue Stakes to dig a window well?

Yes. Blue Stakes of Utah requires notice at least 3 business days before any excavation, including egress window wells. Requests can be made online 24/7 or by calling 811 or (801) 208-2100, and homeowners use the DIY’er path. After lines are marked, dig by hand within 2 feet on either side of each marking.

What is the frost depth in Davis County?

Clearfield’s design criteria, effective July 1, 2026, list a 30-inch frost line depth, along with a 39 psf ground snow load and a 10°F winter design temperature. Frost depth matters for footings and also affects how window wells are backfilled and drained. Confirm the design values your city uses with its building department.

How do I keep water out of my egress window well?

Give the well a drained gravel base, and connect it to the footing drain or a sump where that is practical. Set the liner top slightly above grade, slope soil away from it and keep downspouts away. A cover helps keep out snow and debris. If water still collects, have the drainage and grading checked.

Can I put a cover over an egress window well?

Yes, and many Davis County homeowners do to keep out snow and debris. Under the IRC, any cover or grate over an egress opening must be releasable from inside without keys, tools or special knowledge. Choose one rated for the snow and foot traffic it will see, and confirm requirements with your city’s building department.

Talk to a Davis County basement contractor

Lift Construction is based in Syracuse and installs egress windows as part of basement projects across Davis County, from permit drawings and Blue Stakes requests to drainage and final inspection. Learn about our basement services, contact our team, or call 801-683-6803.

Written by the Lift Construction team, led by owner and general contractor David Carter. Code and program details were checked against the official sources linked above as of October 2026 — always confirm current requirements with your city before you build.