Quick answer: Davis County homeowners finishing a basement can often claim Enbridge Gas ThermWise rebates for wall insulation ($0.30/sq ft at R-11 or higher), efficient windows ($2.50/sq ft at U-0.22 or lower), a high-efficiency furnace ($300–$350), a smart thermostat ($50–$75) and an ERV ($300). Rocky Mountain Power’s Wattsmart incentives changed February 27, 2026, so check current offers before you buy.
Key takeaways
- Enbridge Gas ThermWise pays $0.30 per square foot for wall insulation in increments of R-11 or higher and $2.50 per square foot for windows with a U-value of 0.22 or lower.
- ThermWise furnace rebates are $300 for 95–97.4% AFUE and $350 for 97.5% AFUE or higher with an ECM motor; an energy recovery ventilator earns $300.
- You may install attic, wall and floor insulation yourself, but air sealing and duct work must be done by a ThermWise authorized contractor to qualify.
- ThermWise appliance rebate requests must be postmarked within 6 months of installation.
- Rocky Mountain Power changed its Utah Wattsmart Homes incentives on February 27, 2026; check wattsmarthomes.com for current amounts.
Which basement finishing upgrades qualify for Utah rebates?
The upgrades most likely to earn a rebate during a basement finish are wall insulation, replacement or new windows, a high-efficiency furnace, a smart thermostat and balanced ventilation. Enbridge Gas publishes those amounts on its ThermWise rebate hub.
A basement finish is a natural time to capture these rebates. The walls are open, the mechanical system is being extended, and you may already be cutting a new egress opening. Planning rebate-eligible materials into the scope from the start costs less than retrofitting later.
Rebate programs change, and each has eligibility rules for who can apply and what equipment qualifies. Use the amounts below as a planning reference, then confirm current terms on the program’s own page before you buy anything.
What ThermWise rebates can you get for a basement finish?
ThermWise offers weatherization rebates for insulation and windows and appliance rebates for heating and ventilation equipment. These are the amounts listed as of October 2026.
| Upgrade | Requirement | Rebate |
|---|---|---|
| Wall insulation | Increments of R-11 or higher | $0.30/sq ft |
| Floor insulation | R-19 or higher | $0.20/sq ft |
| Windows | U-value 0.22 or lower | $2.50/sq ft |
| Air sealing | Authorized contractor | $200 + $0.10/sq ft, max $850 |
| Duct sealing | Authorized contractor | $100 + $5.25/linear ft, max $450 |
| Gas furnace | 95–97.4% AFUE / 97.5%+ AFUE with ECM | $300 / $350 |
| Smart thermostat | Qualifying model | $50 or $75 |
| Energy recovery ventilator | Qualifying model | $300 |
| Direct-vent gas fireplace | FE 70%+ with electronic ignition | $200 |
| Gas tankless water heater | Qualifying model | $300 |
Sources: the ThermWise weatherization rebates page and the ThermWise appliance rebates page. Equipment efficiency details are in the Utah equipment specs PDF.
How do insulation rebates work on basement walls and floors?
The basement insulation rebates Utah homeowners can get through ThermWise pay per square foot, with walls qualifying in increments of R-11 or higher. You may install insulation yourself and still qualify, but read the program terms to confirm your basement walls fit its definitions before you count on the money.
Walls
Uninsulated foundation walls are a major source of heat loss in a finished basement, and Utah’s code adds its own energy amendments to the 2021 IRC. Your insulation plan has to satisfy code first; the rebate is a bonus on top. Moisture control matters as much as R-value against concrete, so plan the wall assembly with your contractor.
Floors
The floor insulation rebate requires R-19 or higher. Floor insulation rebates typically target floors over unheated space, such as a crawlspace or garage, rather than a basement slab. If part of your project includes a cantilever or a room over the garage, ask Enbridge whether it qualifies.
Rim joists and air sealing
The band of framing that sits on top of your foundation wall is a common source of drafts. Air sealing qualifies for $200 plus $0.10 per square foot, up to $850, but only when a ThermWise authorized contractor does the work.
Do new basement windows or a new furnace qualify?
Yes, if they meet the efficiency thresholds. Windows must have a U-value of 0.22 or lower to earn $2.50 per square foot, and furnaces must hit at least 95% AFUE to earn $300.
Egress windows
If you’re adding a bedroom, you’ll need an egress window that meets the IRC, which Utah has adopted (2021 edition), including at least 5.0 square feet of net clear opening for a below-grade window. Choosing a unit with a U-value of 0.22 or lower lets the same window earn the ThermWise window rebate. Confirm egress details with your city’s building department.
Furnace, thermostat and ventilation
Finishing a basement adds conditioned space, so it’s a good time to ask whether your furnace is sized and efficient enough to serve it. A Manual J load calculation answers the sizing question; the rebate covers part of an upgrade if you need one. A smart thermostat ($50 or $75) and an ERV ($300) round out the mechanical rebates.
For help choosing the heat source itself, see our guide to the best heating options for finished basements. If you’re adding fresh-air ventilation, our post on basement ventilation requirements in Utah explains where an ERV fits.
What about Rocky Mountain Power Wattsmart rebates?
Rocky Mountain Power runs its Utah home rebates through Wattsmart Homes, and those incentives changed on February 27, 2026. Check current amounts at wattsmarthomes.com before you buy equipment.
According to Rocky Mountain Power’s home savings page, the February 2026 update changed window offerings and added appliances, heat pumps and weatherization. The page doesn’t list dollar amounts, so we don’t quote them here.
Not every Davis County home buys power from Rocky Mountain Power. Check your electric bill to confirm your provider before you plan around Wattsmart.
How do Davis County cities treat energy upgrades in a basement permit?
Energy work in a basement finish goes through the same permit as the rest of the project, and some cities ask for extra documentation. West Bountiful, for example, requires an energy analysis (ResCheck or Manual J/D) when the work changes heating or cooling performance.
- Design temperature: Clearfield’s 2026 design criteria list a 10°F winter design temperature, the figure a heating load calculation starts from.
- Online portals: Layton, Bountiful and Sunset take permits through CityInspect; Farmington uses iWorQ; Clearfield and South Weber use CivicReview.
- Other cities: In Syracuse, Kaysville, Centerville and elsewhere, ask the building department whether it wants load calculations with your plans. West Bountiful homeowners can also see our West Bountiful service area page.
How do you claim basement rebates without losing them?
Collect your documents during the project, confirm contractor requirements before work starts, and file within the deadline. ThermWise appliance rebates must be postmarked within 6 months of installation.
- Check eligibility first. Read the current program terms for the rebates you want before you buy materials.
- Match the contractor rule to the task. Insulation can be self-installed; air sealing and duct work need a ThermWise authorized contractor.
- Keep spec sheets and receipts. Save the AFUE rating, window U-value label and insulation R-value for every item.
- Photograph insulation before drywall. Once the walls are closed, you can’t show what’s behind them.
- File promptly. Mark the 6-month postmark deadline on your calendar the day the equipment goes in.
Rebate-related work still needs a permit when it’s part of a basement finish. See our Davis County basement permit guide for city portals and inspection steps.
Frequently asked questions
Does Enbridge Gas give rebates for basement insulation in Utah?
Enbridge Gas ThermWise offers $0.30 per square foot for wall insulation added in increments of R-11 or higher and $0.20 per square foot for floor insulation of R-19 or higher. Homeowners may install insulation themselves. Read the current program terms to confirm your basement walls or floors qualify before you rely on the rebate.
Can I get a rebate for an egress window?
Possibly. ThermWise pays $2.50 per square foot for windows with a U-value of 0.22 or lower. If the egress window you choose meets that rating and the program’s other terms, it can earn the rebate while also meeting the IRC egress requirements Utah has adopted. Confirm egress sizing with your city’s building department.
How long do I have to submit a ThermWise rebate?
ThermWise appliance rebate requests must be postmarked within 6 months of installation. Keep your receipts, model numbers and efficiency ratings together as the project moves along, and file as soon as the equipment is installed. Check Enbridge’s current rules for weatherization rebate deadlines and paperwork, since program terms can change.
Do I need a special contractor to qualify for ThermWise rebates?
It depends on the work. Attic, wall and floor insulation may be self-installed and still qualify. Air sealing and duct work must be completed by a ThermWise authorized contractor to earn a rebate. Confirm the requirement for each item on Enbridge’s rebate pages before work begins so you don’t lose eligibility.
What Rocky Mountain Power rebates are available for a basement finish?
Rocky Mountain Power changed its Utah Wattsmart Homes incentives on February 27, 2026, adjusting window offerings and adding appliances, heat pumps and weatherization. The company’s home savings page doesn’t list amounts, so check wattsmarthomes.com for current offers, and confirm on your bill that Rocky Mountain Power is your electric provider.
Talk to a Davis County basement contractor
Lift Construction is based in Syracuse and finishes basements across Davis County. We can help you plan insulation, windows and mechanical work so the rebate paperwork is ready when the job is done. Contact us or call 801-683-6803, and learn more about our basement finishing services.
Written by the Lift Construction team, led by owner and general contractor David Carter. Code and program details were checked against the official sources linked above as of October 2026 — always confirm current requirements with your city before you build.